Interested to Buy Any Domain ? << Click Here >> for more details...
How does a 3 phase induction motor is started?
- 3 Answers
- 7283 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / hunnsweethitesh007@gmail.com
when the 3 phase supply is given
to the stator of the 3 phase
induction motor the rotatory mag
feild is producd and feild is
cut by the conductor placed at
rotor and emf is induced due to
this curent is flow in cnductor
and it rotates and motor action
take place
| Is This Answer Correct ? | 26 Yes | 1 No |
Post New Answer View All Answers
what is the difference b/w absolute encoder and incremental encoder?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
Explain what is use of lockout relay in ht voltage?
Work done in a free expansion process is
sir vizag steel ka junior trainee ka paper kitne number ka ayega
please send me previous year questions of jspl through which i could prepare myself for the test.
How wire size can define in electrical wiring? What is the ratio?
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
WHAT IS DOL STARTER? HOW IT WORK? GIVE ITS CONTROL AND POWER DIAGRAM .
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
hi this is hema can anyone mail me previous years questions for the APPSC-A.E.E (in electrical stream.) ......thank u.
Why compensation is necessary in feedback control system?
can the measured percentage error during calibration of single phase energy meter be negative?
Can a generator runs after getting 1st stator earth fault.
