Interested to Buy Any Domain ? << Click Here >> for more details...
what is the calculation of current when a clampmeter is
attached to two phases of any drives.
- 3 Answers
- 6037 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / natchi
vector sum of the two phase currents
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Any one can explaination about calibration with rotating sub standards?
How to test IR testing & magnetic balance test
Write the current equation in series RLC circuits.
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
What is ideal IR values for ground and neutral.
as a electrical student why should i hire you?
how copper and aluminium wires or cables are choose for current rating? please provide copper and aluminium wire selection chart for different current rating ?
If the Brush of DC motor is shifted by 90 deg, then what happens to voltage and torque? Both voltage and torque are zero. how to justify the answer?
how to calculate compresor capacity?
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
What was your role in the silicon evaluation/product ramp? What tools did you use?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
Which do you think is the most significant cause of energy loss in a factory?
Why GRR starts from 60% of motor speed why not less than 60%?
What are the types of windings present in the ceiling fan? What winding will be effective first when we started the fan?What are the resistance and inductance ratios comparatively at the initial speed and full speed of the fan?
