WHAT IS THE THUMB RULE FOR DECIDING THE CURRENT RATING OF
COPPER WIRES SAY 2.5/4/6/10 MM SQUARE SIZES??
- 14 Answers
- 60600 Views
- Dubai Group, Saudi Delta Groups, Savitha Electricals, I also Faced
- E-Mail Answers
Answer Posted / ramprakash
answer 9&12 is currect
| Is This Answer Correct ? | 0 Yes | 8 No |
Post New Answer View All Answers
how does high earth to neutral voltage affect electronic equipment?
Why does an induction generator is preffered as compared to synchronous generator in especially a wind energy power production project?
Can i use the B-curve MCB instead of C-curve MCB
i karmveer bharti persuing b.tech . plz send me syllabus and name of reference books. for preparation of section eng.
How we can come to know the substation range,without go through any name plate ?
what is the best method of grounding in 30 MW generator?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?
What does a Bode plot tell you?
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
In how we connect watt meter for open & short circuit test of a single phase transformer.
Why air circuit breaker off due to power failure?
What is non-minimum phase transfer function?
How do we arrive at selecting reactive capacitance value as 30% of h.p rating of motor?
