How to calculate the CFM to TR?
What is the Formula
Answer Posted / mahendra patil
1tr =? btu
Is This Answer Correct ? | 39 Yes | 18 No |
Post New Answer View All Answers
What are the functions of different probes used in cro?
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
In CTs tan delta point should be earthed , what is the reason behind it?
How to select the gauge of wire for winding of motors? How to select number of turns for winding of three phase induction motor?
Why only sinusoidal ac voltages are generated?why not triangular or sawtooth?
brief notes on ammeters
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
why dimmerstate always connected in star connection? what will happen if it connected in delta?
How to calculate multiplication factor in kva example 500kva ans pls ?
How npn and pnp transistor works
what is the calculation method to design core and winding of a 200kva 3phase distribution transformer?
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
How to Calculate The sag of OPGW in Transmission Line???