In case of motor Power Factor Generally We Apply A Capacitor
But How Can We Know That A Motor is Running On Very low Power
Factor And What Rating Of Capacitor We Have To Place And Tell
Me Conversion Of Micro Farad to KVAR>
- 2 Answers
- 3025 Views
- I also Faced
- E-Mail Answers
Answer Posted / bikkinas
According to its operating efficiency and output.
| Is This Answer Correct ? | 0 Yes | 7 No |
Post New Answer View All Answers
How to calculate approximate load loss of a distribution transformer by knowing %ge imp of transformer?
difference between semiconductor & conductor & insulator?
Can Anyone suggest the Standards (IEC or IS) for selecting copper current density?
Tell me in detail about c.t. And p.t. ?
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
what is sustainable current of any conductors . a bare busbar or pvc cable has different sustainable current .
how hydrogen cooled alternator undergo maintanence ? that is hydrogen when come in contact with air can result into explosions .
How to select circuit breakers rating eg. if i select a circuit breakers of capacity 40 amps DC with operating voltage 28 volts and if i what to use same circuit breakers for 300 Volts DC application what is the current rating of this circuit breakers.
how to calculate the breaking capacity of different breakers.
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible
If mutual flux is 1.2wb & power factor is 0.8 lag , then what is the Useful flux of a transformer?
why the protection turbo generators is most complex?
what is the difference between fault current ant short circuit current?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
