How many loops are there in the power plant? how many closed &
open loop in the power plant ? Please give me the exact
clarification?
- 2 Answers
- 6923 Views
- Lanco, Reliance, I also Faced
- E-Mail Answers
Answer Posted / ch amir islam
dear infact numbers of loops eitherr thz r open or close
depends on the required system & process.any how these
loops are used on demand of process.as relitively ur
question in which kind of system u want to ask about
COMBINE CYCLE POWER PLANT or OPEN CYCLE POWER PLANTS.open
loops depends on the system reliability if u want to check
morer parameters on ur HMI or at CONTROL DEVICE
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
what is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
What is the use of control cable?
what is performance test.need defination
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
what is intrinscily safe system and where we use?
What is the use of single seated valve?
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
what effects a surging can produce in the compressor
In which principles tx ,pressure gauge,Temp gauge,control valve works?
what is the minimum power (P=VI)to produce a spark?
What is the basic difference between Modbus and CAN Open Protocols
sir, give me placement papers and interview quistion of birla group company of copper.
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
