Interested to Buy Any Domain ? << Click Here >> for more details...
At what load maximum effiecency will be obtained
Distribution transformer and Genarating transformer Pls
clarify?
- 4 Answers
- 10912 Views
- I also Faced
- E-Mail Answers
Answer Posted / mahmoud amin
For Distribution Transformer it is at (50% to 80%) load
For Generator Transformer it is at 95% load
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
what is inverter and converter
List advantges of active filter over passive filter?
Safety of dry type transformer
how to test and calculat the head and discharge in borewell compressor
what is the formula for calculating the phase clerance between two phases and phase to earth how to calculate the cable for a motor
i have a 1500kVA transformer what is the kWH meter i need to use?
what r substations?what r there work?why voltages r incresed and then reduced during distribution of power
What is value of earth resistance required for substation and equipment earthing and what are the reference guidelines
Please provided formula for calculate the cable size from step up transformer to M.V panel, run overhead aluminum cables, total load is 5mega watt, total length 900 feet.
What is true sine wave or pure sine wave inverter?? Is it sine wave or step wave?? If it is step wave, waves with how much step is considered as pure sine wave? Is it possible to produce pure sinewave using power electronics?
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
What is CCM in Electrical ? where can we use this material?
