How to find out the quantity of steel FE415
- 16 Answers
- 57792 Views
- Bhel, L&T, TATA, I also Faced
- E-Mail Answers
Answer Posted / mohammed mohiddin
1. Unit wt of steel Ws = 0.785 kg/cm^2/meter length.
2. Crossectional Area (As) of steel can be found using
formula
As = pi x d^2/4
where d = dia of rebar in cm.
3. Now, wt of steel = Ws x As kg/m
Eg:
Take,
d = 16 mm
Wt of steel per meter lenght = 0.785 x 3.1428 x (1.6)^2/4
= 1.58 kg/ meter length of bar
This can be simplified for calculation as below:
Wt of steel = square of dia in mm/162 (kg/ meter length)
Note:- This is very simple method where we must remember to
mention dia in millimeter to get result in kg per
meter length of rebar.
...Good luck...
| Is This Answer Correct ? | 22 Yes | 1 No |
Post New Answer View All Answers
Water filter calculation formula
how much need cement bags for block work of wall approx 1000 hollow blocks 20x20x40cm
Steel requirement in kg of 6" thk slab Total qty 32.64 m3 Beam / column qty 35.39 m3
how to calculate detail quantity of bricks and mortar for 500 cu.ft masonry work. consider wall thickness 9 inches
Define What is the difference between routing maintenance and major maintenance in school facilities?
What is the frequency of sampling for the materials of cement,Fine aggregate, Coarse aggregate .and refer which code
Spider cracks occur in beam bottom due to––
contractor receive 100 MT steel.after compliting the work the contractor refund 90 MT steel.How reconsilation of steel done?
5. Two long boundary walls run parallel to each other at a center to center distance of 1 meter apart. The width and height of the first wall are 0.30 m and 2.5m respectively. While those of the second are respectively 0.18m and 3.5m. Plot the distribution of vertical stress intensity due to walls on a horizontal plane, 1m below ground level. The walls have negligible depth of foundation and are made of brick masonry (y = 19.2 kN/m cu)
Before casting a basement roof slab which is connected with retaining wall surcharge load (i.e. sand or earth filling) outside the retaining wall is prohibited because of––
What is meant by engineering drawing?
PLS.......... ANY ONE CAN FORWARD ME PREVIOUS QUESTION PAPER hpcl civil engg
What are the different theories of failure under static load?
What are the applications of the modulus of elasticity?
What is unit weight of roadway layer.. 1.bitumen 2.sand 3.soil 4.concrete 5. aggregate give me some reference for this answers
