132 KV TRFO BUSHING CT BURNT WHEN A 6.6KV HAS BEEN APPLIED
TO IT .WHY .ANY REASON ?
- 3 Answers
- 6589 Views
- vguard, I also Faced
- E-Mail Answers
Answer Posted / siva.e
In 132KV transformer primary voltage is high.but in 6.6KV
transformer primary current is high when compared to 132KV
transformer so the coil get burned.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
hi frnds what is meant by harmonics & what is meant by third hormonics,where its will occur ?thank u
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
what are symmetrical and non symmetrical components in electrical installation.
what are the things that can cause a three phase motor to crawl?
what is cathodic protection and why it use in industries?
how diside ct mf exmp.200/5 ct
what is the path of thunderlightening? once both a buffalo and a person were standing 5m apart but lightening hit and killed buffalo not person?
What are n circles?
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
what is distribution board?
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
What is control system?
explain remenance . differentiate high remenance type ct & low remenance type ct
1.What will be stored in online ups EPROM IC?
