give me the mix proportion for design mix concrete M10 grade
1:4:8
- 13 Answers
- 61224 Views
- Gammon, IOCL, PSL, SDG, Simplee, STUP Consultants Pvt Ltd, I also Faced
- E-Mail Answers
Answer Posted / sunil1505
its not a design mix. after m25 that called design mixes...
1:4:8 cement,sand,aggregate..water ratio is 0.4
m7.5 1:6
10 (1:4:8 and 1 :3:6)
15 1:2:4
20 1:1.5: 3
25 1 : 1 : 2
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
WHERE CAN I GET THE PREVIOUS QUESTION PAPERS OF APGENCO FOR THE THE POST OF Tr.ASSISTANT ENGINEER(CIVIL)
HOW MANY BAGS OF CEMEMT USED IN PER M2 OF PARTITION WALL
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
Can anyone suggest how to determine scheduling of reinforcement of floor beams from Staad model,other than clicking each beam respectively 7 noting down the values ?
I'm preparing to to build a simple house, but i don't know how to calculate how much cement, gravel and sand and hollow blocks i need to prepare. How many pcs of 4" or 6" hollow blocks I need for my planned 3mx6m house? thanks.
I am practising engineer. I am searching for tutorial of RCC T Girder design Example in staad pro.Do anybody has this?please help
How do you measure concrete?
how to calclate the SHUTTERING TAKEN CONCRETE LOAD? WHAT IS THE LOAD BEARING CAPACITY IN STEEL SHUTTERING PLATE? WHAT IS THE CONCRETE LOAD IN (MASS) IN THE SHUTTERING PLATE. PLATE SIZE IS 120CM* 90CM CONCRETE WALL LENGTH IS 10M ,WIDE IS 60CM, HEIGHT IS 1.2M PLS TO SENT THE CALCULATION.
i want to ecil (Electronics Corporation of India Limited Hyderabad) previous civil engineering question papers immediately please.............
What is the strength of cement?
On what basis we decide the formation level of the road? other then that of 50% Cutting and 50% Filling??
What is the purpose of Chipping in the heavy foundation?
Thumb rule for steel qty for 1m2 in kg/m2 column slab footing beam
Whats the standard thickness of 20'/30' wide rcc service road and what will be the estimated cost per cubit feet
Basic questions of civil engineering
