Interested to Buy Any Domain ? << Click Here >> for more details...
why are we adopting 132kv,220kv for transmission rather than using 440kv at all transmission lines as it gives lower losses?
- 2 Answers
- 6720 Views
- APGenco, I also Faced
- E-Mail Answers
Answer Posted / parshuram
because transmission line losses means voltage drops due to area of conductor diameter is more, so that y , if we make high voltage transmission line is inversly propational to area of the conductor size wiil be reduced.........so its tramission efficency is high...
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
how many parameters can integrate with fire alarm basically ?
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
What does ampere turns shows?
how to calculate singlephase motor efficiency?
how to select size of hardware for linking aluminium busbar is it depend on area of busbar or current flowing through bus bar
Give details on how you intend to handle a challenging position you are posted to manage unexpectedly as a company staff?
can you please send me the technical questions and aptitude questions of honeywell and jindal steel electrical engg. question paper my e-mail ID is(kkesavanraj@gmail.com)
why effective resistance should be more than static resistance in transmission line?
What is meant by Load Encroachment in OHL Feeder Protection?
why need to be maintain power factor for industrial customer?
Why we find the sensitivity for the CT's to check?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
what is diff. between earthing grid,earthing mess, earting grid?
