WHAT IS C.C IN AUTOMOBILE????
- 11 Answers
- 15997 Views
- IBM, Pricol, TATA, Tata Motors, I also Faced
- E-Mail Answers
Answer Posted / sagar
cubic centimeter
| Is This Answer Correct ? | 16 Yes | 6 No |
Post New Answer View All Answers
Which theories of failure are used for ductile materials ?
What is general pressure ratio for axial, reciprocating and centrifugal compressors?
State fourier’s law of conduction.
Will a steel cable become longer if it is heated while under load? Explain
How is ceramic defined ?
tell me about a time when u had too many things to do and u were required opinion prioritized your talks
Dear Sir, i need previous technical question papers, if possible so please tell from where i got these papers.
HOW TO PREPARE FOR HPCL WRITTEN EXAM?
Define a machine shop?
difference between 1st angle and 3rd angle projection
Explain how can I see where pipes are behind the wall?
Enumerate some trouble of fuel injection valve
en 19 & en24 which one is good for pipe mill shaft
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
What is the purpose of stern tube?
