If DC supply is given to a transformer it may
a) Work
b)Not Work
c)Give lower voltage than the rated voltage on secondary
side.
d)burn the winding
- 12 Answers
- 13327 Views
- wbsedcl, I also Faced
- E-Mail Answers
Answer Posted / puja sinha
b)it will not work.because a transformer works on the
principle that an alternating flux is produced bya an
alternating quantity that oppose the main field.if the
supplied quantity is not alternating <alternating flux is
not produced and the transformer will not work.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What will happen if the d.c. Shunt motor opened accidentally running on no-load has its shunt field winding?
Testing procedure of DG alternator stability test
Why 3 phase induction motor getting supply in body if one of it's phase is cut
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
CPC cable .PVC \1C....I want to get sure that type is flexible indoor or to be install on trench. please advice .thanx :)
can indirect loading be called as phantom loading?
# 4 hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible my email id is sumit_lig189@yahoo.co.in
what are inherent currents?
What Is Connection APFC Panel In Compony.
What is inverse definite minimum time lag relay? Where is it use?
can some one clearly explain why -48 volt DC use in telecom site????
why we use ac supply as 415 volts instead of 415 v why we cant apply 230 v for dc
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
Why the power factor improvement is so important in industrial loads
How to derive detailed design of Suitable bus Bar for 100A for 6.6KV?
