Interested to Buy Any Domain ? << Click Here >> for more details...
when an induction motor runs on load.at that time if we
reduce the supply voltage the current increases.But when it
runs without load,if we reduce the supply voltage the
current also reduced.why?.i checked it practically also.
- 1 Answers
- 4215 Views
- Birla, I also Faced
- E-Mail Answers
Answer Posted / dilawar patel
when motor runs on load ;there is a load who will draw
more current if u reduce the voltage load will draw more
current because it is essential to run the desire load ,
Formull V=IR,...when ther is no load nobody is there to
draw the more current ,so current reduce if u reduce the
supply voltage
| Is This Answer Correct ? | 5 Yes | 5 No |
Post New Answer View All Answers
why the name trunking bus PT
11000volt DG set carnt kaise banvay
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
What are the reasons for the parallel operation of transformers?
Explain the experiment on ward leonard method of a speed control on a dc shunt motor with an suitable circuit diagram.
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
What is effect of over voltage and under voltage on ACB
1.how many types of relays? 2.difference between ATS& STS?
what is upper impedance and lower impedance of a distance relay
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
