Interested to Buy Any Domain ? << Click Here >> for more details...
What is mean by power factor?
- 18 Answers
- 28032 Views
- Shreem Electric Ltd, I also Faced
- E-Mail Answers
Answer Posted / rajeev democrat
1. It is the ratio of real power(active) and apperent power.
p.f = kw/kva
2. It is the cosine angle bet voltage and current.
It is denoted by the angle of cos.
3. It is the ratio of useful power to total power in the circuit.
4. In the resistive circuit power factor will be one bcs of no any reactive power here(ideally).
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is deference between MCB & MCCB & ISOLATOR
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
A power transformer 4MVA/11KV/0.415Kv has been out of use in 12years. what maintenance actions/test need to be carried out before energizing.
why chock were used in old tubelights but are not newest tubelights?
What is the difference between type1 and type2 relay protection co-ordination for motor feeders
Explain the difference between verilog task and verilog function?
Earth is a conductor or load?then ammeter connect to 3- phase supply,it shows the measurents or not?
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
Explain what is electric traction?
Pls explan the OLR setting in VCB at HT yard
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
why we use ac supply as 415 volts instead of 415 v why we cant apply 230 v for dc
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
what is meant by LCR meter? where its useful ?
