Interested to Buy Any Domain ? << Click Here >> for more details...
Transformer's core is made up of which material and why so?
- 10 Answers
- 32111 Views
- ABB, NTPC, I also Faced
- E-Mail Answers
Answer Posted / pruthviabbur
transformer core is made up mainly by iron.viz it it
supports for magnetic path and for current also.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
Explain Energy and Power signals?
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
what parameters are should nessary for control technic dc drive(in rolling mills)?
How to know th details about an electrical Drawing ? Please mention the easy method.
How can ou verify the size of conductor 50Sq.mm ACSR
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
How the setting of the vector surge relay shall be calculated when the relay is to be used for Grid islanding application?
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
what is the power rating of CPU, CRT type moniter, LCD type moniter,scanner Approx.
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
Readings of ER300P Trivector meter
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
What is servo motor and what are different types of servo motor
