Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate full load current of transformer &
induction moter ?
- 2 Answers
- 7325 Views
- I also Faced
- E-Mail Answers
Answer Posted / raj
for full load current in transformer we need to short the
secondary terminals,and in IM we have to block the shaft
with full load
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is ATS & RING MAIN UNIT in Distribution System?And its Function.
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
what is mean by PIR in circuitbreaker and give me detail of that?
what is current check gurd relay?
In siemens PLC, why do we want to move the data ?
How to Calculate the Fault Level of Electrical Installation
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
internally connection of photvoltic module
What are the advantages of hydropower?
What is CCM in Electrical ? where can we use this material?
What is Tachometer used to measure?
what is differentila pilot supervision in the incomer control panel in the power station?
If a rotary UPS is in line through grid power; What would be the impact on Power Factor if the load through rotary ups is 25% , 50% , 75% & 100%. Will the power factor reduce with less load?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
What are the reasons for the parallel operation of transformers?
