Interested to Buy Any Domain ? << Click Here >> for more details...
difference between fleming's left hand rule and RHR briefly.
- 3 Answers
- 11529 Views
- I also Faced
- E-Mail Answers
Answer Posted / rohit
Fleming's right hand rule is applied for generator where
middle finger points current
left hand rule is applied on motor
Rohit Rathore
rohitkumarrathore@gmail.com
fy electrical birla college
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
What are the advantages of autotransformer?
what is mean by descripiency relay? & wht is its ansi code?
What are the specifications for conducting earth leakage test as per IEC standard?
Is a 300w induction motor used in a food processor as powerful as a 1000w DC motor.
v/f drive basic princeple
What is the minimum value of hfe for the oscillations in transistorized rc phase shift oscillator?
if any house we instaled a 1.5 ton ac and its phase cable of wiring is installed but netrual cable of wiring not instaed. my question is that is neutual of house(for other wiring is capable for ac load or a sepeart neutrual wiring required
The loads are connected with phase and ground then why current flow as the loads ?
Generator,motor and alternator Working principal Please explain easily
Why derivative controller is not used in control systems?
what is the control circuit for operating the clean room air shower
what does a string of resistors in a series will do?
what is upper impedance and lower impedance of a distance relay
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
Can we use both Electrical & mechanical interlock between tow breakers? if yes how, please explain
