Interested to Buy Any Domain ? << Click Here >> for more details...
why Batteries & Battery chargers are used in substation?
what is the different between UPS & battery charger?
- 4 Answers
- 52767 Views
- DLF, I also Faced
- E-Mail Answers
Answer Posted / muhammad mustaghas
1) The operation of monitoring devices such as relays and
the tripping mechanisms of breakers require an independent
power source, which does not vary with main source being
monitored.Batteries provide this power source for the
successful operation of switching and control devices in
power protection system.
It is therefore necessary to ensure that batteries and
charges are regularly inspected and maintained at the
highest possible level of efficiency at all times to enable
correct opeartion of relays at the correct time.
2)UPS means uninteruptable power supply which accept AC as
input and convert this AC into DC for the storage purpose
and when require AC supply then again it convert DC into AC
for its out put terminal.Basically UPS is used to stored
the energy in from of current to fullfill the requirement
for emergency supply but batteries only provide the DC
power supply to its load and can store and supply the
limited amount of power.
| Is This Answer Correct ? | 21 Yes | 4 No |
Post New Answer View All Answers
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
What are root loci?
We have given to 3phase supply to ups system & how can coming netural
what's the simultenous maximum demand (SMD)..what the diffrent MD and SMD?
what type of earthing do for dry fissure rock?
What are the advantages of a three-phase system over a single-phase system?
What is K-rated transformer? What is the use of it? What can be the size(pls provide calculation if possible) of K- factor transformer for 550kW,690V motor operating with drive (VFD)?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..
how to set relay setting? and example calculation...
What does the term supermesh means?
if i am in front of transmission line how to know that current direction without any equipment
How to select a cable size for particular load?
what is meant by brushed alternator & its working principle ?
State kirchoff current law?
