Interested to Buy Any Domain ? << Click Here >> for more details...
avr is an automayic voltage regulator ... it regulates
voltage before it synchronise with grid after
synchronisation it regulates power factor why....
- 7 Answers
- 9283 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
It is possible to have the changeover from AVR to APF mode
automatically on synchronization / closing unit CB and the
vice versa, using auxiliary switch of the breaker.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to select the gauge of wire for winding of motors? How to select number of turns for winding of three phase induction motor?
what is earth pit , how we can measured it, what earth rods reference
What is the difference between AC and DC injection methods for rotor earth fault protection
How to calculate LT XLPE CABLE for 11 kv / 433 v , 1000 kva oil type transformer system?
Motor,transformers,capacitor tubelight etc....
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
Tell me about ur past electrical maintanence job
how ct burden,magnetising current,ratio and knee point voltage are related & derived
What is DTR erection?
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
1. Why is the speed of shunt motor practically constant? 2. Why dc series motor use to start with heavy loads? 3. advantages & disadvantages of separately excited generator over self excited generator?
What descriptive information does the NEC require to be marked on all conductors?
What is the function of auadag in a cro?
Why the symbol of register is "zig zag"
