avr is an automayic voltage regulator ... it regulates
voltage before it synchronise with grid after
synchronisation it regulates power factor why....
Answer Posted / balu
Once the generator connects with the grid the system voltage depends upon to the grid referrence.the active power varies depends on the load.so load varies mean time reactive power also variey.so avr will maintaine power factor after synchronization.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Will an earth leakage trip be activated if the component or wiring is faulty on low voltage equipment.Example An electrical Cat Scarer placed in the garden and water gets into the wiring.
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
differnce between single acting and double acting solenoid valves
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
what is the purpose of high speed earth switch in gas insulated substat
HOW WE CAN REDUCE THE CIRCUIT COMPLEX OF STAR-DELTA STARTER .BECAUSE NOW WE USING ONE TIMER RELAY & THREE CONTACTOR FOR MAIN,STAR & DELTA ?IF ANY IDEAS PLZ POST.THANK U
difference between Ac and Dc mcb ????
State the formula for overall efficiency of thermal power station
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
Can u Explain about the electronic trivector meter and the use of data converters in them?
What are the conditions for sustained oscillator or what is backhouse criterion?
What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)
How to Make relay co ordination chart for a Electrical power distribution of a plant
why occ characteristics of generator is also called as magnatization characteristics ?
Explain about technical and non technical losses in distribution system?