Interested to Buy Any Domain ? << Click Here >> for more details...
what is impedence (Z) of transformer, what indicate in
transformer , which perameter indicate in transformer
- 5 Answers
- 12922 Views
- CTS, Suzlon, I also Faced
- E-Mail Answers
Answer Posted / sivaramakrishnan.s
You can see the %impedance in the nameplate details.
Transformer designed depend on the full load Current.
Actually.. How much %primary voltage required to flowing the full load current at secondary side when secondary is short circuited called as %imp volt in transformer. It will be %volt of Transformer primary voltage..
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is the difference between transformer,converter and transducer
What are the types of instrument transformer?
What is CCM in Electrical ? where can we use this material?
what is mean by parallel operation of permanent magnet generators
is there any current and voltage drop on liquid resistance starter water/soda tank ?
Please brief working principle & construction of permanent magnet AC Servo motor
What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?
what topics we have to concentrate for power grid et.written test.and tell what to read for english synonyms and antonyms.
How npn and pnp transistor works
How many types of electric motors are there?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
What does the term “voltage regulation” means?
How would your past experience translate into success in this job?
what is ps impedance test
What do you mean by transformation ratio of instrument transformer?
