Interested to Buy Any Domain ? << Click Here >> for more details...
Please explain about FAT? What is the difference between
FAT and SAT?
- 6 Answers
- 33047 Views
- IBM, I also Faced
- E-Mail Answers
Answer Posted / ajay
FAT: it is the acronym of Factory acceptance test i.e.
Tests performed under simulated conditions at
manufacturer's place witnessed by approving authority
client/End user.
FAT is performed to check the correctness of the system
being supplied. FAT covers all checks over hardware,
interfaces, logics & control loops and system configuration
as per the procedure defined in FAT document.
FAT is performed for Control/DCS & PLC panels.
SAT: it is the acronym of Site acceptance test i.e. tests
performed under live signals received from instruments
installed in plant during the actual commissioning of the
system at site/ end user's place. During SAT, all live
signals are checked and individual control loops & logics
are performed accordingly.
Once all individual loops and logics are checked, then only
plants process is left to run through control system itself.
| Is This Answer Correct ? | 20 Yes | 1 No |
Post New Answer View All Answers
What is the working principle of the magnetic meter?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
How do you identify an orifice in the pipeline?
what effects a surging can produce in the compressor
what is the difference between active & reactive power?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
Questions on flow meters,few questions on HART protocol,
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
I will attend an interview with GasGas company for a position of Instrument Technician ( Offshore )in next month can anyone tell me what questions they will ask. Thanks in advance.
Calibration procedure for Electro magnetic Flow meter
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)
Why even multiple power supplu r used in instrumentation system?
What is difference of fanuc alpha series 16i and 18i controller.also what is differnce betn TC and MC controller
