Answer Posted / midhun

Calculation and selection of required capacitor rating
Qc = P * {tan [acos (pf1)] - tan [ acos (pf2)]}
Qc = required capacitor output (kVAr)
pf1 = actual power factor
pf2 = target power factor
P = real power (kW)

what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?

1925

---

What is pole of the system?

1133

---

what is the ATS .And how it works.

1607

---

What is meant by impedance? difference between high & low impedance ?

2054

---

what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks

1968

---

What is the RME and explain the full form and what is the RME work?

2825

---

What is float cum boost charging system?

2053

---

if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit

1863

---

where is the need for short circuit test for 3 see is required and why? can you explain in brief with application

1945

---

define digital electronic

1981

---

How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.

1881

---

how will calculate the safe starting current of 3-phase squirrel cage induction motor?

1911

---

Explain how you intend to work under pressure to meet up with deadline target?

5219

---

what are the difference between PLC and embedded

2137

---

what is x'mer ,isolation x'mer & yltra-isolation x'mer?????

2464

---