Interested to Buy Any Domain ? << Click Here >> for more details...
can you give main difference between ELCB And RCCB?
- 38 Answers
- 172869 Views
- MCB Bank, Reliance, Wipro, I also Faced
- E-Mail Answers
Answer Posted / raviraj.c
ELCB:-An ELCB is a specialised type of latching relay that
has a building's incoming mains power connected through its
switching contacts so that the ELCB disconnects the power
in an earth leakage (unsafe) condition.The ELCB detects
fault currents passing from live (hot) to the earth
(ground) wire within the installation it protects. If
sufficient voltage appears across the ELCB's sense coil, it
will switch off the power, and remain off until manually
reset. An ELCB however, does not sense fault currents
passing from live to any other earthed body.
RCCB:-A residual current device (RCD), or residual current
circuit breaker (RCCB), is an electrical wiring device that
disconnects a circuit whenever it detects that the electric
current is not balanced between the phase ("hot") conductor
and the neutral conductor. Such an imbalance is sometimes
caused by current leakage through the body of a person who
is grounded and accidentally touching the energized part of
the circuit. A lethal shock can result from these
conditions; RCDs are designed to disconnect quickly enough
to mitigate the harm caused by such shocks.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is order of the system?
what is meant by 3rd hormonics ?
What is the power requirement of tamil nadu for one month?
How is operate breaker failure scheme in substation
Why 3 phase induction motor getting supply in body if one of it's phase is cut
wat system call?
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
Write the force balance equation of m ideal mass element.
Why is better to have a minimum ceiling voltage of 250% than 160%?
HI....HOW CAN BE MESARED THE VALVE OF NEUTRAL GROUND RESISTOR WHIC IS LOCATED AT SWICHGEAR ON GENERATOR SIDE....
how we can calcultae the short circuit level for bus bar
What is the unit audit? if our Max demand is something and we found much more unit then how to improve our max demand?
how calculate the electrical load for industry and office
While HT line put on to activate ACB in low tention panel VCB tripping instantly.why it happens
electrical knowelge
