Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between real and reactive power? and what is the importance of these
- 3 Answers
- 6967 Views
- I also Faced
- E-Mail Answers
Answer Posted / ravi chaurasia
Real power is the power which is actually required to operate
the connected load in power sysyem.Reactive power is the
waste power from electricity board point of view but it is
the inherent requirement of the inductive loads.
In short it reduces the capacity of cables and transmission
line but is inherent requirement of the load.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
33kv substation lay out details & line to line & line to earth measurements
How Diesel Generator start ?
Why hydropower is called renewable source of energy?
which type of effect of turbine and generator reverse power protection ?
what is vtg limit of earth and neutral at transformer side?
Y phase plates are used in transmission line??? what is there need???
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?
What is the difference between amorphous core transformer and CRGO core transformer?.
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend
what is ratio of copper wire size and current ?
Which type of transformer is used for lighting loads?
What are motor generator sets and explain the different ways the motor generator set can be used ?
What is the end effect of linear induction motor ??
