Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate cut bar length of steel reinforcement?
- 7 Answers
- 50704 Views
- BCON, Jindal, MAT, I also Faced
- E-Mail Answers
Answer Posted / srinivassan
50 times diameter of the rod
lap lenght ex: 20 mm rod lap length - 50*20 = 1000/300= 3.33
| Is This Answer Correct ? | 13 Yes | 17 No |
Post New Answer View All Answers
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
What is Curtailing of R/F
What is the difference between 53 grade and 43 grade cement
How musch steel i.e. angles, channels,and square pipes are required per square feet for a steel roof of residential two storied building?
What in bending moment, if a moment is free end of cantilever beam?
why steel tanks are provided (a) for water pressure (b) for wind pressure (c) for earthquake pressure
what is the use of beam end forces while using a staad ? wha they are show
what is the use of steel rods of 16mm or 20mm used for 4.45mts for closing gutter.one mate consumes how many kgs with a gap of 6inches.
how much quantity of 1.5" nails and 2.5" nails are required for conventional formwork shuttering?
What is Time period of a building and its relation with frequency ?
How to calculate quantity of cement , sand and granite from concrete mix ratio and volume of work
do you think we shall remove un wanted soil for foundation excavation even if the thickness of the soil strata is more than 8m ?
plz drive the formula d2/162.162 for the calculation of weight of steel bars????
why should we use 20mm graded metal only in vrcc?why we shouldnot use 40mm metal?
Which are the Steel tests ?
