Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rao
ELECTRONICS AND ELECTRICAL ENGINEERING
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
Explain bypass capacitor?
what is the purpose of silicon dropper used in battery charger?
what's the exact magnitude of current, flows through Neutral?
what is the vvvf in the dumbwaiter?? or lift. what is the actual process?/
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
WHY IN AC DRIVES,INPUT PHASE CURRENT SHOW UNBALANCE?
After taking shutdown of 11kv feeder, if you see 5kv by phasing stick in the cable side, is it possible to close earth switch in cable.
what is the best method of grounding in 30 MW generator?
im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar
Is there any rule to select the voltage of motor based on KW rating? What is the rating above which lt motor becomes the HT motor?.
WHAT IS VCB SAFETY
Why power genaration in India is at 50HZ while America its 60HZ
What is meant by a stray loss of a induction motor??? What is the equation to find it
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
