Why we are putting off the APFC(automatic power factor
control) panel while the generator is running?
Answer Posted / k.prakashchandra
APFC is for use while gen is running only.It is not
preferred as it may lead to voltage rise whenever there is
sudden network failure.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
what is doid
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
Whether it is possible to measure energy at the input of rectifier transformer (12 pulse with very high odd harmonics)
what is allowable ac mixing in dc
How to calculate the Harmonics losses in terms of cost/unit.
How can we find the breaking capacity of a Load breaker switch (LBS) fed from 11 kv supply??ex:50KA, 26kA etc???detailed step vice answer pls.
what is quality factor in series resonance circuit and calculate the factor of voltage magnification? how it happens?
What consists of 2 or more thermocouples to be connented series?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
how can maintaince the acb contactor moveing and fixing kit
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m
State the points to be considered for selecting a particular type wiring.
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
why i can not use thimble on capacitor duty contactor
could you measure current in parallel?