Interested to Buy Any Domain ? << Click Here >> for more details...
Why Clock rate command is not configured on ethernet
interface of a router?
- 6 Answers
- 15127 Views
- I also Faced
- E-Mail Answers
Answer Posted / thilak
Clock rate is used for synchronization between sender and
receiver.for serial connections we need to specify the
clock rate as its protocol dont have the capability to sync
by itself as such in ethernet protocol.ethernet protocol
uses preamble part of the header to sync between sender and
receiver.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is the minimum and maximum request timer?
Explain the difference between switch & hub?
Mention the ranges for the private IP?
Which table find best path?
What is the advantage of vlan?
What is the working of router?
Explain the difference between baseband and broadband transmission in ccna?
What is ad in ccna?
What is half duplex and full duplex?
Explain the difference between igp and eigrp?
What are the two types of transmission technology use in ccna?
Can you define LAC
what is the concept of HA and FA in VPN tunneling?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
How many valid ip will b in /21 in route summarization?
