What is the d/f between DOL & star delta starter & automatic
star delta starter?
- 23 Answers
- 158406 Views
- ACC, Dalkia, Engineering, Indeco, NINL, Novotel, RMH Control Systems, Wipro, I also Faced
- E-Mail Answers
Answer Posted / h.l.kiran
in DOL we are going to connect 3 phase supply directly but
it will capable for less current if more current flows
through it the starter will get damage. while starting the
motor it will take more current, for reducing this start up
current we r going to star-delta connection. in this first
will be in star conection after that it will turn to delta
connection.
| Is This Answer Correct ? | 6 Yes | 5 No |
Post New Answer View All Answers
How to calculate approximate load loss of a distribution transformer by knowing %ge imp of transformer?
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
what is effect of length of air gap on performance of dc motor and generator?
explain different types of d.c motors?
How will polarity test of Dy5 Transformer ?
LT cable fault chaecking equipment and to find out the distance at what distence it failure . Name and where it is available?
What are the advantages of thermal power plant?
What is MSL designation of a motor and same may be provided in details.
hi if anybody got model questions for cpcl Grade'A' electrical engineer position.send it to my mail please krishkumar22@gmail.com
How to find ampere on ht side for selection of cable size ???
how invertor convert the dc into ac give brif detail
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
how mass curve differs from hydrograph.
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
