Interested to Buy Any Domain ? << Click Here >> for more details...
We have laid the single core Armoured cable 7 nos ( 2 each
phase & 1 neutral ) to cater our electrical load .
the issue is though we have Glanded the cable both the end
also givan the earthing to the panel both the end we are
facing a heavy sparking at the gland side. what could be
the reason.
- 12 Answers
- 17050 Views
- I also Faced
- E-Mail Answers
Answer Posted / robertm
It sounds like you have a loop, check and see if the
neutral and the earthing cable are laid down on the same
bars. If this not the incoming service then that could
cause your problem.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
bus bar design conditions and sizing pls tell me quickly
How Can I calculate for the photometrics requirements for a street lighting? Data given are: 45 units of 6 meter light pole with 150 watts metal halide lamp, 220 volts and installed in a promenade area.
I need model question papers for RRB section engineer Chennai... Please send to my E-mail Id:- maitheerainbow@gmail.com
Explain Continuous and Discrete signals?
which metal is use in shunt
In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
what is gas turbine intercooling ?
i need the details about bhel exam.how to apply for that.please send to my email-id.thenmozhi2k7@gmail.com
List the time domain specifications.
FEINGING DECREASES THE FLUX DENSITY IN THE AIR GAP. HOW?
Has someone here done a sizing for a generator (3 phase), its for a pumping station. If you have an example for standby/duty and both running (I) star delta (ii) Soft Starter.
explain transformer ct connection?
How to calculate mf when meter equipment and meter are connected
How to calculate earth wire load by formula
