Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate busbar size & what is the procedure we
make for determine that?
- 35 Answers
- 217796 Views
- Auko Tex, Integra, PowerTech, Shadhin Group, I also Faced
- E-Mail Answers
Answer Posted / santhoshsasidharan
CURRENT DENSITY OF CU=1.2A/MM2
CURRENT DENSITY OF AL=.8A/MM2
FOR EX: DESIGN REQUIREMENT OF 400A MAX.CAPACITY.
CONSIDER THE BUSBAR IS CU.
AREA OF THE BUSBAR=400A/1.2=333.33MM2
APPROX. VALUE= 350MM2
SO THAT, THE STANDARD SIZE IS 50MMX8MM
| Is This Answer Correct ? | 33 Yes | 9 No |
Post New Answer View All Answers
Factory acceptance test. FAT. For 132 kv transmisstion towers what is that meaning and what are the tests commonly companies perform now days.
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
Do closed loops systems require manual input?
how is the testing of an REF relay? what are the test REF circuit having?
how many electricity poles are there and what are the names and their sizes.
Lt motor sfu flashing reasons?
What are the types of windings according to the construction?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
What are the factors influence the choice of an electrc drive?
what is integrated ac contact circuit
Is any generator is developed which is operated with out diesal or other expensive source?
can we use engine degreaser for electrical motors?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
what kn of disc is used in 33kv,132kv,220kv,400kv,800kv transmission line
If I bring a basic electric meter from the States and hook it up in Costa Rica in a development that has only one transformer for the 50 homes, will it still be accurate regarding the usage of kilowatt hours?
