Interested to Buy Any Domain ? << Click Here >> for more details...
what is the function of cooling tubes in transformer
- 4 Answers
- 26844 Views
- I also Faced
- E-Mail Answers
Answer Posted / v jyothi kumar
heat is produced in a transformer winding due to iron and
copper losses. this heat is absorved by oil.cooling tubes
are used for transformer oil cooling and coolig systems are
two types they are
1. Natural cooling.
2. forced drought cooling.
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
What is a difference between indoor transformer and outdoor transformer of same rating
what is RNG in the DG synchronizing by PLC?
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
suri transmission
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
what is the minimum winding resistance of 30hp compressor, to run or to switch on
what is reactive power?, why its measured in VA ? is it transient behavior of system?
What are dcs and plc?
What consists of 2 or more thermocouples to be connented series?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
Difference between control junction box (cjb) and power junction box(pjb)?
what are your career plans upon completion of the programme and the relevance of recity generation to your professional development?
