Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nanjilll
Procedure for the calibration of Pressure switch:
1.decide the required set point
2. check the switch contact is Normally Closed or Normally Open.
3.connect the multimeter between NC & Common and Select to continuity measurement.
4.apply the pressure by using hand pump or other pressure making tools(Hydraulic or Pneumatic)
5. check the change in continuity in multimeter.
| Is This Answer Correct ? | 23 Yes | 7 No |
Post New Answer View All Answers
Who to difference between analog in & analog out in dcs?
Which type of diagphram use in costic line,DM water line,natural gas line,oil line?
the output of the common trasmitter protocol in qatar gas are the following
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
What is force balance principle? State some of its’ advantages.
How does temperature bath work? How does coil gets heated only by applying some current?
where proximity sensor installed on tank in loading arm application
why fuse block is not used for AI signal?
How do bending tubing provide better measurement than using tubing fittings such as elbows?
How to calibrate Toxic gas detector?
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
What are the uses of orifice plates?
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
How to Calibrate Level Switch in field
