Interested to Buy Any Domain ? << Click Here >> for more details...
how to calibrate a control valve?
- 7 Answers
- 64039 Views
- Reliance, Telecon Systems, I also Faced
- E-Mail Answers
Answer Posted / jayesh
If the valve is SMART now we can use a HART communicator to calibrate the control valve.Give the supply pressure according to the valve name plate then use HART communicator and give 0% 25% 50% 75% & 100% check the travelling of valve
| Is This Answer Correct ? | 52 Yes | 12 No |
Post New Answer View All Answers
Draw a P& ID showing – orifice flange, plate, dp transmitter, isolation & bypass valves and tubing.
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
Calibration procedure for Electro magnetic Flow meter
what is the difference between scaler and vector drive
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
what is sliding spool valves?
in valve is constructed as per SME B 16.34, then which standard is used for fire testing of valve?.
plz send me general of ongc
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
What is intrinsic safety mean.
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
how to calibrate corollaries (Mass flow meter)?
components of control circuit belongs to control valve
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
