Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kumaran
i think most of the DCS writing C , C++ language
| Is This Answer Correct ? | 6 Yes | 37 No |
Post New Answer View All Answers
Why even multiple power supplu r used in instrumentation system?
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
Explain Gas Turbine startup and shutdown sequences
Why plc require in analog input 4-20amp & 0-10 volt?
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
all types instrumentation questions want
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)
Calibration procedure for Electro magnetic Flow meter
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
