what is the ground clearance of 400KV transmission line?
- 9 Answers
- 31027 Views
- Power Grid, wbsedcl, I also Faced
- E-Mail Answers
Answer Posted / guest
11m
| Is This Answer Correct ? | 5 Yes | 8 No |
Post New Answer View All Answers
why sometime we get electrical shock while touching the ballon of dish tv connection ? which we should not get.
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
How many types of interlocking use in screw type air compressor,make-Kaser(BSD MODEL)?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
what are the precuation should be taken ahen installing power transformer,circuit breaker,current & potential transformer
how to compare with Relay settings for HT< panels, RMU panel, and PSS CSS transformer?? 1) Load amps, 2)Tripping time, 3) CT ratio, 4)Cable size 5) Transformer KVA rating 6) transformer full load amps
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
WHat is the general checks required for Dry type transformers
can any one suggest me the tilt angle of my solar pannel ?? or tell me how can i know the fix tilt angle of my solar pannel?? my cordinates are 31.503629,72.993164.
what is meant by rotating magnetic filed
What is pi controller?
What is the most important precaution in any experiment with d.c. Shunt motor?
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
Write the current equation in series RLC circuits.
