Interested to Buy Any Domain ? << Click Here >> for more details...
1.why ACB is not connected in HT side what Happens?
2.how much voltage maintained in ACB breaker?
3.OLTC is connected in primary side in case secondary side
connected what happened?
- 3 Answers
- 8958 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / karthikeyan
ACB there is a limit of current may pass through the contact machanism.High voltage side not possible to connect the ACB.
ACB max voltage can be maintained up to 415 volts that means it is purely applicable in LT side.
OLTC not possible to connect in secondary side because secondary side there is a continious load connecting that cause a huge problem may occur in sec side.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What is meant by bus bar protection?
Why mostly the HV side of transformer has Delta?
What is the Minimum winding resistance of motors ( small & big)? referance range
if you are in a software company,then why do you want to come in a core company like sail, ntpc(where lots of trouble like tension but you have a good life in a it company) ?
how to convert lv line to hv line and viseversa, any losses will occur during this process
What is the complete procedure of erection of electrical panel in industry
why industry prefer ht motor instead of lt motor.
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases slip A does not alter B decreases C increases D none of above
What are the advantages of stationary armature and rotating field system?
Difference between Earthing Truck & Earthing trolly for HT panel
how maney type tempereture measurement ?
what type questions asked in hp cl
how to generator maintenance (A Check, B check,Etc)
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
