Why a ballast and ignitor is required in MH and other
lighting fixtures
- 2 Answers
- 4162 Views
- Future Group, I also Faced
- E-Mail Answers
Answer Posted / manoj kumar sahoo
A ballast & ignitor is required in MH & other lighting
fixture because its takes high voltage in starting and
normal voltage in running periods.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Explain about Leakage Test.
Why it is possible to use PWM with a STATCOM and not with a conventional TCR based SVC
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
What is measurement?
diff b/w normal grounding and resistance grounding
why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
Can i replace Earth leakage relay to the faulty Earth Faulty Relay
What is called grain-oriented laminations?
it is possible to measurement of tension of slipring induction motor(SRIM)carbon brushes, any maesuring instruments are available in the markets.
specific difference of ICT&Auto Transformer
How to design harmonic filter at the project stage without nowing the harmonics levels
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
what is the transformer turn ratio formula and give some examples?
What do you mean by passive circuit elements and why these are called passive?
