What is Generator Protection & Transformer Protection?
- 3 Answers
- 11667 Views
- Areva, I also Faced
- E-Mail Answers
Answer Posted / n k singh
Generator protection means protecting the generator in case
any abnormality occurs on generator and transformer
protection means protection of transformer in case any
abnormality occurs on transformer.
General generator protections are:
1.U/F Protection
2.U/V Protection
3.Excitation failure protection
4.Protection against prime mover failure.
General Transformer protections are:
1.Overload protection
2.Ground /Earth fault protection
3.Restricted earth fault protrection
4.Winding temperature high protection
5.Winding protection.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
What is Fire Panel ? How it works ?
i have 500 amp inductive load of motors ,,,pleas tell me how can i calculate for capacitor bank for improving my power factor to 99 .....calcullations for capacitor bank,,,,
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
what is servo motor & how does it work.
For electrical designers what are the standard should know? i want learn about this standards. how to get information/reference. anybody help in this regards please.
can u please mail me the syllabus for GET exam for damodar valley corporation?
Name one of major transformer company in KSA ?
Can we Co-ordinate relay in Load Break switch?
why we use sinosidal voltage / current instead of others in system?
What happens to a line-frequency of high-frequency transformer when it is first energized/ re-energize?
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
What are the various kind of cables used for transmission?
why ahould you show client/engineer activities clearly on the project plan
What is dynamo function in DG sets and draw block diagram?
why moisture formation found in XLPE Armoured cable outer sheath
