Interested to Buy Any Domain ? << Click Here >> for more details...
1.why ACB is not connected in HT side what Happens?
2.how much voltage maintained in ACB breaker?
3.OLTC is connected in primary side in case secondary side
connected what happened?
- 3 Answers
- 8896 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / anil kumar parashar
this is not how ,u r saying .....but OLTC is connected to
the HT side of the transformer so that while changing the
tape on-load, the arc will be minimum because HT side of
transformer have a less current than the LT
side .........the current will be as low as the
transformation ratio will high.
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
whats the existence of reactive power and when it arises?
how can we change the phase angle b/w two phase?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
Single phase and threephase power calculation
if main CT is of ratio 50/5, and meter CT is -/5 what will be overall multiplying factor of meter.PT is 11000/110 .
how to measure the current by compact digital equipment with dislay which fit inside any equipment
What is Negative Potential Bias
why servomotor motor? where i apply for best output?
if a.c supply is given to the motor,, what happen?
how to calculate the conductor size for certain KV transmission line and distribution line?
what is the difference between the characteristics of two different phase bushing of any transformer
What do you mean by turns ratio of instrument transformer?
What is PQA???Applications........
