Interested to Buy Any Domain ? << Click Here >> for more details...
what happens when a power transformer neutral earthing
broken???
- 11 Answers
- 22630 Views
- MacLellan, I also Faced
- E-Mail Answers
Answer Posted / privin p v
according to KCL midpoint of a star connection is zero potential.If the load of the transformer is balanced nothing happen while neutral earthing broken.But in case of any unbalancing occurs there is no way to go the circulating current and heat occurs.It will damage the transformer
| Is This Answer Correct ? | 14 Yes | 1 No |
Post New Answer View All Answers
Please tell me the formulaes while designing a substation for power Calculations in designing a 33 KV Substation?????
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
what is the carona effects meaning in HT line transmmission system
what is diff. between earthing grid,earthing mess, earting grid?
how to find the Motor,s insulation Power?
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
What the main causes of transient interruptions on Over-Head Distribution Lines?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
What is “pu” in electrical engineering?
HOW CAN WE DECIDE THE SUPPLY VOLTAGE FOR MOTOR ACCORDING TO ITS RATING(IF ANYONE KNOWS GIVE IT WITH EXAMPLE AND ITS CALCULATIONS)
What is the difference between alternator and generator?
Can double compression glands be used with regular cables?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
What is the approximate value of stacking factor?
