Interested to Buy Any Domain ? << Click Here >> for more details...
why 4-20 mA signal is preferred over a 0-10V signal
- 17 Answers
- 75993 Views
- Sofcon, I also Faced
- E-Mail Answers
Answer Posted / maiatec
The main reason is that the current 4-20mA can reach long distances without loss of information. The current does not alter because it is a loop without derivations. Moreover, with the voltage of 0-10V can not reach long distances due to voltage drop on the resistance of the wire.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is the difference between working pressure and calibration pressure of a control valve
hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
What is the GK Value in Flowmeter?
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
Full form of KKS when use DCS.
Difference between dcs and plc including date processing and architecture.
Explain bernoulli’s theorem. State its application.
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
I want to know about DDCMIS in detail ? please explain it. Also give name of reference books in which it is explained in detail in very simple manner.
How to calibrate Toxic gas detector?
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
What is the difference between ff transmitter and non ff transmitter
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
