how much load should be given on 5 mva transformer
- 7 Answers
- 26736 Views
- NTPC, OHPC, Power Grid, I also Faced
- E-Mail Answers
Answer Posted / addicted to know electrical
Load means current,not Mw(power).So,by looking at
P=VI*p.f....
Since i is load which is always variable....the power drawn
from the transformer will always vary......and hence it is
not inour hand how much load shall be given to the
transformer but the efficiency will be max. when load is
equal to iron loss divided by square of secondary
resistance.
| Is This Answer Correct ? | 2 Yes | 23 No |
Post New Answer View All Answers
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
How to calculate energy stored in a capacitance
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
how to calculate units consumption for a 12 hp motor /hr.
what is difference between elr and R eartl realy.
What is inverse definite minimum time lag relay? Where is it use?
What are the three constants associated with a steady state error?
what purpose to use excaiter in DG.?
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
In HI POT test what is reason for applying the AC VOLTS and DC VOLTS in different applications what is the nessesity for this ?
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors
What should be current in the Primary and secondary side of 1000KVA (11KV Supply)Transformer.?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
why do we have spikes enough to burn electronic boards, when generators are not grounded
