Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mahender mohal
Simply transformer is a power transfer device not a power
consuming device,so it have negligible loss (depends on
volt-ampere),so cos$ is >0.96 approx. 1.P=vi;due to this
reason x-mer rating is in VA Or KVA.
| Is This Answer Correct ? | 4 Yes | 8 No |
Post New Answer View All Answers
Why computer humming sound occurred in ht transmission line?
which metal is use in shunt
i completed my DEEE. and i want to electrical c license. how to get it..?
HOW TO TEST A LIGHTENING ARREST ER ?
What is load boxes ?
why the neutral point in connnection oscillates?
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Which do you think is the most significant cause of energy loss in a factory?
what is difference between 5A and 100A CT constructional wise and operation?
please send me privious exam's queation papers of section engineer(electrical).
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
what the function breaker failure scheme, how is it operated
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
