Answer Posted / navaneetha
copper losses depends on current and iron losses depends on
voltage. Total transformer loss depends on volt-ampere (VA)
and not on phase angle between voltage and current i.e., it
is independent of load power factor. That is why
transformer's rating is in KVA
| Is This Answer Correct ? | 33 Yes | 1 No |
Post New Answer View All Answers
What happen when neutral point connected to core balance current transformer? (Neutral point of an alternator of a 180KVA DG. Neutral point connected to CBCT means enter to the CBCT)
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
what is mean by D.O. in distribution line poles?
Can you explain about TEE protection scheme?
Which motor connection is preferable star-delta or delta-star?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
Difference between On Line capacitor and Station Type capacitor.
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
area control error
what is the use of permanent magnet generator in exciter
According to conduit size which size wiring & how many wires can we provide wires in conduit & how can we select conduit size accordingly?
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
What are the relays in ACB and VCB
What is FM200 Gas??Applications........
