Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / satypaty
Incomer panel works as incoming source in control supply.
Its not necessary to take PT in Incomer feeder.in some cases typical feeders eg.BPT,LPT are used for PT. Incomers PT are used to gives the auxillary supply to meters and relay.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
I have a 380 KVA DG set. How can i find out 1. My Fuel Consumption per hr ? 2. Electricity produced in 1 Hr. ? 3. If load varies then how does it affect fuel consumption & electricity produced ? Please HELP !!! Really need an answer.
How much minimum insulation required between 11kv/3.3kv transformer windings?
All tape of electrical questions Answers tape of motor transformer e.o.t crane
a 230v transformer with step down ratio 19:1.it has 2000turns on primary and rated 25va calculate max primary current no of secondary turns volts/turn
Define step response?
What is the slip speed?
Which cable is use for rtcc control panel
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
how dose servo motor works
how calculate gd2 of ht motors
When color of silica gel will gets change from blue to pink from Top to bottom?
What is the drawback of class b amplifier?
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
Please brief me about number of pole in alternator.In single phase alternator coils are connected in star or series. How to calculate frequency for the same.
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
