Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sreekanth
If a PID Setpoint is derived from another PID then the loop
is called cascade loop.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is the calibration procedure for transweigh make weigh feeder?
what would be the minimum flow rate that we can measure on rotameter..?
Difference between ultra sonic flow meter
please tell no. & add. of consultancy who recruit me in power plant as instrumen engg. present i m working in power plant as ass.t instrument engg. thanku mahesh 09226562826
line up procedure for dp type flow transmitter?
How to Calibrate Vibration Probe (Axial, Redial) in field
What are different types of orifice plates?
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
Can anyone send most commonly asked interview question in Oil & Gas industry
Hi,can anyone help me out with PhD programs related to Instrumentation field?I have a degree in electronic Instrumentation?
Explain an adaptive / self-tuning controller’s major draw card.
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
