Explain the laying procedure and laying depth of submarine
cables under sea?
- 1 Answers
- 3592 Views
- Schneider, I also Faced
- E-Mail Answers
Answer Posted / abhinav
An underwater electric power cable which has a minimum
radius of curvature to which it can be bent without damage
and which can be suspended between underwater suspension
points in no greater than a predetermined length for a
desired service life is layed by first laying a flexible
steel rope along the desired underwater course and
adjusting the rope position and length so that there are no
curvatures thereof less than the minimum radius and no
lengths thereof greater than the predetermined length, and
then, the cable is layed alongside the rope so as to follow
the configuration of the rope.
burial depth can be 5 metres for 132 kv .
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is meant by cold loop test in instrument
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
what is the difference between interconnection and intraconnections in the circuit diagrams
working principle of AC Servo Motor with its construction
Please tell me the power flow from pmg to main rotor of an alternator (Including AVR unit)?
What is the function of capacitor in electrical circuits?
can u please mail me the syllabus for GET exam for damodar valley corporation?
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
How is operate breaker failure scheme in substation
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
bsnl tta exam question
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
Why we are going for converter transformers for DC drives application instead of distribution transformer?
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
Give some differences between open loop and closed loop control systems.
